Inland Arduino Compatible Basic Starter kit Attached below is a .PDF that will walk you through some great projects for all the different components that are included in this kit. 426312 Inland Starter Kit.pdf Here are some examples of what projects are featured!Flame sensorLED chasing effectTraffic lightPulse width modulation (PWM)Blinking LEDPotentiometer sensorThis kit includes:UNO R3 Plus Board; 6 feet USB type A to mini-B; 2 x Tact push switch 6mm x 6mm through hole; DIP switch 4 position through hole; 1K Ohm potentiometer (variable resistor) long pins; 10K Ohm potentiometer (variable resistor) long pins; 20 x 330 Ohm axial resistor, 1/2W, 5%; 5 x 1k Ohm axial resistor, 1/2W, 5%; 5 x 10k Ohm axial resistor, 1/2W, 5%; 2 x LED through hole Red, 8.7mm height, ~2V drop, ~10-20mA; 2 x LED through hole Yellow, 8.7mm height, ~2V drop, ~10-20mA; 2 x LED through hole Green, 8.7mm height, ~2V drop, ~10-20mA; 2 x LED through hole White, 8.7mm height, ~2V drop, ~10-20mA; 2 x LED through hole Blue, 8.7mm height, ~2V drop, ~10-20mA; 2 x Two digits 7-segment LED RED; Buzzer, x5Vo-p; 2 x NPN transistor; Breadboard 30 columns x x14 rows (include x2 VCC and x2 GND); 10 x 6" male-to-male jumper wires (red); 10 x 6" male-to-male jumper wires (black); 10 x 6" male-to-male jumper wires (white); 10 x 6" male-to-male jumper wires (grey); 10 x 6" male-to-male jumper wires (blue); 4x AA battery enclosure with DC power jack and ON/OFF switch, cable length 4"; 2 x 2cm x x2cm x 3mm thick double side tape; Information sheet Arduino UNO diagram + basic electronic theory; Kit container