-
ReadyView - How to Install the Water-resistant Connector/Coupler
The ReadyView100 foot Ethernet cables come with the weather-resistant connector installed on one end. Simply connect the Ethernet connector to the camera, push the weather-resistance connector on to the camera connector, then turn to lock in place.
-
ReadyView - Camera Image Black and White and Not in Color
ISSUE The image is in black and white rather than in color. CAUSE In low light conditions, the image may switch to black and white. SOLUTION The image will automatically switch to color when there is sufficient lighting.
-
ReadyView - LED Behavior
The WD ReadyView NVR has LEDs on the front and back. Below is information on both panels. The front panel LEDs are shown below.
-
ReadyView - How to Reset the NVR
The WD ReadyView NVR has the ability to be reset. There are two ways to reset the device. Direct Connect HDMI / VGA connection The requires a video cable (HDMI or VGA), monitor, and a mouse (not included). Right-click anywhere on the screen Click Menu Click in the password field Enter the admin password (this was required…
-
ReadyView - How to Set-up the NVR
The WD ReadyView system has a simple 4-step set-up process. Please follow the steps below: To setup the initial NVR Connect the short Ethernet cable to your router, 4 cameras to the longer Ethernet cables, and connect those longer Ethernet cables to the the PoE Ethernet ports on the back of the NVR. It is recommended to…
-
ReadyView - How to Update NVR and Camera Firmware
The ReadyView NVR has firmware that can be updated via the mobile app. Note: ReadyView does not support rolling back the firmware to an older version To update the WD ReadyView device firmware, please follow the steps below: Launch the WD ReadyView mobile app Tap the options icon at the top left corner of the screen…
-
ReadyView - How to Collect System Logs
This article details how to collect ReadyView system logs. The ReadyView has a Web user interface. At this time, only the device reset and log gathering are supported through this interface. To gather/collect the device logs, please follow the steps below: To access the web interface, the device's IP address will need to…
-
ReadyView - Storage Always Displays 0.01GB Free
The ReadyView mobile app the amount of available storage for both internal (NVR) and external devices (if attached) will be displayed. ISSUE: The total storage shows 0.01GB Free CAUSE: The NVR records continuously. SOLUTION: This the normal behavior once the full capacity of the internal drive has been written to (2TB or…
-
ReadyView - Fan Behavior
The ReadyView NVR is equipped with a fan. Please see the following table for the fan behavior. Fan Behavior Table Note: The fan speed will not change based on the device temperature. If the device is powered on and the fan is off it is likely that the device is will need to be replaced. If you purchased at a local Micro…
-
ReadyView - Default Login and Password for the NVR
The ReadyView NVR has a default user name and password that is required to be changed during the set-up process through the mobile app. Please see the information below. Default NVR Credentials