-
ReadyView Support
Welcome to ReadyView Support by Micro Center! We're glad to have you apart of the ReadyView family and hope we can provide answers to any of the questions you may have. Here are some of the most common topics we have discussed with customers. How to Change the NVR Password How to Set-up the NVR How to Reset a Camera Camera…
-
ReadyView - How to Reset a Camera
The ReadyView camera(s) come with a reset button. Please follow the instructions below to reset the camera. 1. Disconnect the Ethernet cable from either end to power off the camera 2. Reconnect the Ethernet cable from either end to power on the camera 3. Once the red LED on the front of the camera comes on and then…
-
ReadyView - How to Access the Web UI
The ReadyView has a Web user interface. At this time, only the device reset and collecting logs are supported through this interface. 1. To access the web interface, the device's IP address will need to identified. The device does not have a netbios name. The router table should list the attached devices and show the IP…
-
ReadyView - How to Install Mobile App
The ReadyView mobile app is available on the Google Play Store and the Apple App Store. Simply download the app from the respective app store and launch to get started.
-
ReadyView - How to Change the NVR Password
There is no physical reset button on the device. The password can be changed back to default by following the steps below. From the mobile app., tap the three bars in the upper-left hand corner of the app Tap CONFIG MANAGER Tap PASSWORD MANAGER Tap CHANGE PASSWORD Tap in the password field After entering new password in…
-
ReadyView - How to Install the Water-resistant Connector/Coupler
The ReadyView100 foot Ethernet cables come with the weather-resistant connector installed on one end. Simply connect the Ethernet connector to the camera, push the weather-resistance connector on to the camera connector, then turn to lock in place.
-
ReadyView - Camera Image Black and White and Not in Color
ISSUE The image is in black and white rather than in color. CAUSE In low light conditions, the image may switch to black and white. SOLUTION The image will automatically switch to color when there is sufficient lighting.
-
ReadyView - LED Behavior
The WD ReadyView NVR has LEDs on the front and back. Below is information on both panels. The front panel LEDs are shown below. Was this article helpful? YesNo Be the first one to vote!
-
ReadyView - How to Reset the NVR
The WD ReadyView NVR has the ability to be reset. There are two ways to reset the device. Direct Connect HDMI / VGA connection The requires a video cable (HDMI or VGA), monitor, and a mouse (not included). Right-click anywhere on the screen Click Menu Click in the password field Enter the admin password (this was required…
-
ReadyView - How to Set-up the NVR
The WD ReadyView system has a simple 4-step set-up process. The mobile app supports up to 5 NVR systems. Please follow the steps below: To setup the initial NVR Connect the short Ethernet cable to your router, 4 cameras to the longer Ethernet cables, and connect those longer Ethernet cables to the the PoE Ethernet ports on…
