I just purchased the P1S and holy moly!

Rye_Bread

This thing is awesome! I had a benchy printed and looking great within an hour of opening the box. I've been printing dozens of little things that I admittedly don't need.

So far, this is the most painless 3d printing experience I've had yet.

Attached is a picture of my Ikea SKÅDIS Pegboard (great accessory btw) and my efforts of moving things off of my desk. There are quite literally hundreds of files on Thingiverse for the pegboard. (Note the SD/USB holder, controller stand, shelf for Quest controllers, hooks for my Rii keyboard, and the holders for my watch and headphones)

As I get more use out of it, I'll most likely do a more detailed writeup.

Feel free to ask me any questions and I will attempt to answer!

Ian

What's the speed like on a larger print?

Rye_Bread

https://community.microcenter.com/discussion/comment/52128#Comment_52128

I haven't done any huge prints yet! I have some cosplay ideas in mind, I'll post them with times once I start them.

That being said, prints that took hours on my Ender 5 Plus take a fraction of the time. Especially when you consider that I needed to manually level and prep the Ender every time I wanted to print. I'm not as savvy as other 3d printer users, so having one that just works on its own is a boon for me.

Howellusn12

@Ian I printed a full wearable mando helmet in about 20hrs maxing out the build plate 

Shoan041

That came out great!

Rye_Bread

https://community.microcenter.com/discussion/comment/52266#Comment_52266

Woah, you were able to fit that in one print? I may have to give that a shot. The cosplay I want to do is mostly Star Wars, so this may be a huge bonus for me.

Ian

https://community.microcenter.com/discussion/comment/52167#Comment_52167

https://community.microcenter.com/discussion/comment/52266#Comment_52266

Great to hear it can handle large prints quite well!