PowerSpec Micro ATX 205 Chassis

PowerSpec_BB

How to install 2.5 SSD drive:

Things you’ll need:

SATA data cable

Four M3 screws

Phillips screw driver (Sizes 0-2)

Make sure system is powered off before adding SSD

• Get the SATA data cable from the accessory kit

• Unscrew the two screws on the back-side panel and slide panel off

• Locate the SATA power cable that is connected to the power supply. (This cable may be bundled next to the power supply.)

• Locate the hard drive bay area

• Screw in all four screws about 1/3 of the way

• Connect the SATA data cable to the SSD, the SATA data cable will connect to the smaller connector

• Connect the SATA power cable to the SSD, the SATA power cable will connect to the larger connector

• Slide the SSD into the mounting holes

• Tighten all four screws

• Plug in the SATA data cable to the motherboard

• Slide the back panel back onto the chassis and screw the two screws back in. Be careful no wires get caught on the side panel, this can cause a wire to become unplugged.