PowerSpec ATX 205 Chassis

Greetings,

This is a guide explaining the chassis buttons.

Power – This button turns the system on. If you hold the power button it will turn the system off

Color – This button cycles through the colors for the case fans

Mode – This button cycles through the fan effects

How to install 2.5 SSD drive:

Things you’ll need:

·      SATA data cable

·      Four M3 screws

·      Phillips screw driver (Sizes 0-2)

Make sure system is powered off before adding SSD

• Get the SATA data cable from the accessory kit

• Unscrew the two screws on the back-side panel and slide panel off

• Locate a SATA power cable that is connected to the power supply. (This cable may be bundled next to the power supply.)

• Locate the hard drive bay area

• Unscrew the screw holding the SSD bay, once unscrewed slide the SSD bay off
• Place the SSD in the bay with the SATA connector facing down
• Line up the screw holes of the SSD with the drive bay and screw in all four screws

• Connect the SATA data cable to the SSD, the SATA data cable will connect to the smaller connector

• Connect the SATA power cable to the SSD, the SATA power cable will connect to the larger connector

• Carefully slide the drive bay back into place on the case and screw the drive bay screw back in
• Take the other side of the SATA data cable and guide it through one of the bottom or side holes of the chassis
• Plug in the SATA data cable to the motherboard

• Slide the back panel back onto the chassis and screw the two screws back in. Be careful no wires get caught on the side panel, this can cause a wire to become unplugged.